Skip to content

Analog design

Analog-to-Digital Converters

Why the number of bits is almost never the thing that limits a measurement, and which of the converter's other properties is.

  • Advanced
  • {# Publicación escalonada: el curso está escrito entero y sale por partes. Decir «3 lecciones» cuando hay diez haría parecer corto un curso completo, y ocultar que faltan haría parecer roto uno que no lo está. §40. #} 10 lessons
  • 1 available

About this course

A converter with more bits is not a better measurement. It is a finer ruler, and a finer ruler applied to a shaking hand measures the shake more precisely.

This course is about everything between the ruler and the hand. Where the converter's own noise comes from and how much of your resolution it eats. What the input of a successive-approximation converter actually does to the circuit driving it, which is nothing like a resistor to ground. Why a reference that is accurate at twenty-five degrees is not accurate at eighty. How a switching regulator two megahertz away can land on top of your signal at DC. And why a clock that looks clean on a scope can cost you four bits.

The arithmetic is worked rather than quoted, and the example is the one the operational amplifier course ended on: a sensor signal amplified to 2.38 V, read by a twelve-bit converter on a 3.3 V reference. One code is 806 microvolts. Every error in this course gets measured against that number.

Course contents

In order. Each lesson assumes the one before it.

  1. ADC Resolution: What the Number of Bits Really Means

    Twelve bits buys you a step size, and a step size is not an accuracy.

  2. SAR ADCs: How Successive Approximation Works

    Available on 17 Nov.

  3. Delta-Sigma ADCs: Resolution, Oversampling and Latency

    Available on 18 Nov.

  4. ENOB, SNR and Resolution Are Not the Same Thing

    Available on 19 Nov.

  5. ADC Input Impedance: Why the Source Sees a Dynamic Load

    Available on 20 Nov.

  6. How to Drive a SAR ADC Correctly

    Available on 21 Nov.

  7. ADC Voltage References: Noise, Decoupling and Drive

    Available on 22 Nov.

  8. Sampling, Nyquist and Aliasing in Real Hardware

    Available on 23 Nov.

  9. Clock Jitter: When Timing Error Becomes ADC Noise

    Available on 24 Nov.

  10. How to Choose an ADC for a Real Design

    Available on 25 Nov.

Other courses

  • Analog design

    Operational Amplifiers

    Why an op amp can satisfy the equation on the schematic and still give the wrong answer on the bench, and which of its limits decided that.

  • Power electronics

    Power Integrity & Decoupling

    Why a capacitor on the schematic is not a capacitor on the board, and how to decide placement, value and count with reasoning instead of folklore.

  • Power electronics

    Switching Regulators

    How a switching regulator actually moves energy, how its parts are chosen, and why the layout is part of the circuit rather than a drawing of it.

The XKEMA newsletter

Hardware engineering worth keeping

New courses, engineering notes and hardware guides, whenever there is something genuinely worth reading. Nothing else.

We will email you to confirm. You can unsubscribe from any issue.